Click on images for higher resolution versions
Click on images for higher resolution versions
 |
Precimold has standardized on Engel molding machines. Almost all of its Engels are equipped with parts removal robots or sprue pickers. |
 |
A CNC mill is used primarily to make EDM electrodes, but also precision machines molded parts. This picture shows the making of electrodes to EDM cavities for aspherical polycarbonate lenses. |
 |
Precimolds molding machines include a 300-tonner. This picture shows a new Nissei 7-tonner used for micromolding. |
 |
An example of an eight cavity family mold. Each of the eight different parts, designed by Precimold, required a cam action to interlock with each other. The final assembly had no screws or other fasteners. The finished product, part of a subway ticket validation system, also was assembled at Precimold. |
 |
Examples of: Two colour molding, Insert molding and Ultrasonic assembly. |
 |
Examples of: Hot stamping and
precision injection molding on computer controlled machines.
Inspection of parts after 4 hours, 24 hours and 7 days guarantee that all parts shipped are to specifications. |
 |
Precision mold making using
modern technologies.
6 cavity mold combining spindle unscrewing with 24 cams. Cost and time saving mold inserts, used in master mold frames for short and long production runs. |
 |
Precimold designs and builds SHARED MOLD FRAME production tools. They consist of standardized mold frames and core/cavity inserts that can be square, rectangular, or round, like this one for a glass filled polyester gear. |
 |
MICROMOLDING. The part in the centre is a wristwatch component. The white parts surrounding it are .0005g 'plugs' molded with a four cavity subgated mold. Surrounding those are red .0050g 'standoffs' molded with a twenty cavity subgated mold, each part with a cavity identification number molded in. |
 |
Small, precise, complex difficult parts. |
 |
Insert molding. |
 |
Hot stamping. |
 |
These polypropylene cosmetics containers are hot runner molded. Precimold runs them with NO taper inside and NO taper outside. STRAIGHT! |
 |
Top right hand photo shows parts that each weigh one half of one thousandth of a gram. Below that is a 30 and 25 per cent glass filled nylon bearing retainer where the mold has run for 20 years. The mold has yet to show signs of wear. |
|
 |
 |
 |
